Olivetti Artjet 22 Installationsanleitung Seite 7

Install the printer software
Before installing any software, read carefully
the Terms and conditions of the user licence
displayed as the first page of the software
installation procedure.
Make sure both your printer and computer
are switched OFF.
If your PC does not have a CD drive, you can:
•
download the printer software from the web
address indicated on the inside front cover,
or
•
create a set of diskettes yourself, using a PC
that has a CD drive.
1. Switch on your PC, start Windows and insert
the Installation Disk CD in the CD drive of
the PC.
2. Install the printer software following one of the
procedures below (a, b, c or d), according to
the operating system and the interface cable
used:
The interface cables are NOT supplied with
the printer. Ask your computer dealer for
details.
(a) Windows 3.1X/95/98/NT + parallel cable
•
Connect the printer to the PC (with the
parallel cable).
•
Press the "POWER" button (
printer operator panel to switch on the
printer.
4
•
From the Windows 95/98/NT Start menu (or
Windows 3.1x File menu), select Run, type
the CD-ROM drive letter followed by
"olisetup" (normally, d:\olisetup) and click on
OK.
The installation menu appears on the screen.
•
Click on Install software and then on Install
printer driver.
•
Follow the instructions that appear on the
screen.
•
Once the installation procedure is completed,
you will be prompted to restart your PC.
(b) Windows 2000 + parallel cable
•
From the Start menu, select Run, type the
CD-ROM drive letter followed by "olisetup"
(normally, d:\olisetup) and click on OK.
The installation menu appears on the screen.
•
Click on Install software and then on Install
printer driver.
•
Follow the instructions that appear on the
screen:
select the LPT port and connect the printer
–
to the PC (with the parallel cable) when
prompted to do so,
press the "POWER" button (
–
printer operator panel to switch on the
printer,
check also that the automatic Plug and
–
) on the
Play installation for the printer is selected
in one of the dialogue boxes displayed.
) on the
Installation Guide