Olivetti Artjet 22 Installationsanleitung Seite 6

Insert the print heads
The figures in this section show the printer in its
horizontal position.
1. Press the "POWER" button (
printer operator panel to switch on the printer
and open the printer co*ver; the print head
carriage will be in the head loading position
and the light indicator will be flashing.
2. Open the black print head container, remove
the print head, holding it by the thumb and
finger grip, and remove the protective film.
Do not touch either the electrical contacts

( - gold-coloured part) or the printing
‚
nozzles ( ) nor sit the print head on them.
3. Insert the print head in the seat on the print
head carriage indicated by the single
engraved dot so that its electrical contacts

( ) match the corresponding contacts in the
seat.
Installation Guide
4. Block the print head, pushing it towards the
release lever until it clicks into place.
) on the
Repeat the above operation for the colour
print head.
5. When you have inserted both print heads,
close the printer cover, then press and hold
(1) and press
buttons together.
2
The print head carriage returns to its rest position
and the printer runs an initialisation cycle that
takes some time (the light indicator continues
flashing until the cycle is completed).
Remember to run the print head alignment
function BEFORE starting any print jobs.
For print head replacement, see the specific
section in this booklet.
GB
(2); release the two
1
3