Olivetti Artjet 22 Installationsanleitung Seite 14

Loading paper/envelopes from
the second feeder
The figures in this section show the printer in its
horizontal position.
You can print up to 10 sheets of paper or 3
envelopes, loading them from the output tray
which doubles as a second automatic feeder. On
reception of a print command, the media in the
second feeder will have priority over that in the
main feeder.
1. Remove any printed documents from the
output tray and open its rear and lateral
guides.
2. Fan the paper/envelopes and load them as a
single pack on the tray, inserting them
carefully until they stop inside the printer,
under the output guide.
The printing surface must face towards the
tray.
Installation Guide
3. Close the lateral guides against the edges of
the paper/envelope and close the rear guide.
Remove the printed document as soon as it
exits from the printer.
Loading a single sheet manually
You can print a single, or thicker, sheet of paper
or special media, inserting it in the manual feeder.
On reception of a print command, the media in
the manual feeder will have priority over that in
both the main and/or second feeders.
qPrinter in vertical operating position
Insert the sheet of paper, with the printing surface
facing upwards, aligning it with the right hand
guide.
Make sure that the leading edge of the paper
is against the feed rollers along its entire
width - you will hear a beep.
GB
11