Olivetti Artjet 22 Installationsanleitung Seite 15

Loading small formats from the
main feeder
The figures in this section show the printer in its
horizontal position.
1. Empty and tip up the output tray.
2. Open the rear guide for small formats on the
paper tray of the main feeder and make sure
that the adjustable margin guides are
completely open.
3. Fan the paper/envelopes and load it/them as
a single pack into the main feeder, inserting
it/them carefully until it/they stop inside the
printer.
Make sure the trailing edge is inside the
intermediate rear guide.
Do NOT load above the maximum level
indicated on the inside of the feeder.
The printing surface must face towards the
tray.
12
4. Close the adjustable margin guides against
the edges of the paper.
5. Return the output tray to its operating
position and make sure that its lateral and
rear guides are open.
Installation Guide