Olivetti Artjet 22 Installationsanleitung Seite 16

Loading a banner
The figures in this section show the printer in its
horizontal position.
You can print a banner up to 5 ft/1.5 m long (5 x
A4 length), loading it from the main feeder.
1. Empty and tip up the output tray.
2. Pull out the adjustable rear guide on the paper
tray of the main feeder and make sure that the
adjustable margin guides are completely
open.
Installation Guide
3. Place the banner as a single pack in the main
feeder.
The first module to be printed must be on top
of the pack and its leading edge must be
facing towards the paper feed channel. The
printing surface must face towards the tray.
4. Close the adjustable guides against the paper
edges, making sure that it is not held too
tightly nor has too much play.
5. Lower the output tray to its operating position
and open its rear and lateral guides.
When the printer is in its horizontal operating
position, the tab on the rear guide must be
opened downwards.
GB
13