Checking The Alternator-Belt Tension - Toro Z Master Professional 7500-D-Serie Bedienungsanleitung

square hole, install the belt around the idler
pulley (Figure 55).
9. Install the belt covers.
Checking the
Alternator-Belt Tension
Service Interval: Every 100 hours
1. Apply 44 N (10 lb) of force to the alternator belt,
midway between the pulleys.
2. If the deflection is not 10 mm (3/8 inch), loosen
the alternator mounting bolts
1. Mounting bolt
3. Increase or decrease the alternator-belt tension.
4. Tighten the mounting bolts.
5. Check the deflection of the belt again to ensure
that the tension is correct.
50
(Figure 56).
Figure 56
2. Alternator
g008932