Toro Z Master Professional 7500-D-Serie Bedienungsanleitung Seite 62

adjustment bolt by rotating it counterclockwise
(Figure 80).
Note:
Loosen or tighten the single-point
adjustment bolt enough to move the
height-of-cut plate mounting bolts at least 1/3
the length of the available travel in their slots.
This regains some up and down adjustment on
each of the 4 deck links.
1. Single-point-adjustment bolt
14. Tighten the 2 bolts at the bottom of the
height-of-cut plate
Note:
For most conditions, adjust the black
blade tip 6.4 mm (1/4 inch) higher than the front.
15. Torque the 2 bolts to 91 to 113 N∙m (67 to 83
ft-lb).
16. Measure until all 4 sides are the correct
height. Tighten all the nuts on the deck lift arm
assemblies.
Figure 80
(Figure 78).
g009042
60