After Operation; After Operation Safety; Using The Drive-Wheel Release Valves; Transporting The Machine - Toro Z Master Professional 7500-D-Serie Bedienungsanleitung

After Operation

After Operation Safety

General Safety
•
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's position. Allow the machine to cool
before servicing, adjusting, fueling, cleaning, or
storing it.
•
Clean grass and debris from the cutting unit,
muffler, drives, and engine compartment to help
prevent fires. Clean up oil or fuel spills.
•
Shut off the fuel and remove the key before storing
or transporting the machine.
Using the Drive-Wheel
Release Valves
Use the drive-wheel release valves to release the
hydrostatic drive system, which allows you to push the
machine without the running the engine.
Rotate each bypass valve counterclockwise 1 turn to
release; rotate each bypass valve clockwise to reset
the system (Figure 29).
Important:
Do not overtighten. Do not tow the
machine.
Figure 29
1. Right bypass valve
g004644
2. Left bypass valve

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure that the length of the ramp is at
least 4 times as long as the height of the
trailer or truck bed to the ground. This
ensures that the ramp angle does not
exceed 15 degrees on flat ground.
31
(Figure 30).