Adjusting The Height Of Cut - Toro Z Master Professional 7500-D-Serie Bedienungsanleitung

Figure 23
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control
levers rearward (Figure
Figure 24
g008952
24).
g008953

Adjusting the Height of Cut

Adjust the height of cut from 25 to 140 mm (1 to 5-1/2
inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. With the engine running, push the deck-lift
switch rearward until the mower deck is fully
raised, and release the switch immediately.
2. Rotate the height-of-cut pin until the roll pin
in it lines up with the slots in the holes in the
height-of-cut bracket and remove it
3. Insert the height-of-cut pin into the hole
corresponding to the desired cutting height
(Figure 25).
Refer to the decal on the side of the deck-lift
plate for the heights of cut
4. Using the deck-lift switch, move the deck height
out of the transport position (or 5-1/2 inches (140
mm) cutting height) and down to the selected
height.
1. Height-of-cut bracket
27
(Figure
(Figure 25).
Figure 25
2. Height-of-cut pin
25).
g227689