Toro Z Master Professional 7500-D-Serie Bedienungsanleitung Seite 61

1. Deck adjustment
2. Jam nut
9. Measure the rear blade tip height. Fine-tune the
rear adjusters as required; use the single-point
adjustment to gain more adjustment.
The rear tips of the side blades should measure
76 mm (3 inches).
10. Measure until all 4 sides are the correct
height. Tighten all the nuts on the deck-lift arm
assemblies.
11. If the 4 deck adjusters do not have enough
adjustment to achieve the accurate height of
cut with the desired rake, you can adjust the
single-point system
Figure 77
3. Adjustment nut
(Figure 78).
1. Single-point height
adjustment bolt
2. Front height-of-cut plate
g231991
mounting bolt
12. To adjust the single-point system, first loosen
the front and rear height-of-cut plate mounting
bolts (Figure
Note:
The mower deck is attached in the front
holes at the factory
the back holes for further adjustment when
leveling the mower deck.
1. Mower deck
2. Front hole
13. If the deck is too low, tighten the single-point
adjustment bolt by rotating it clockwise. If
the deck is too high, loosen the single-point
59
Figure 78
3. Rear height-of-cut plate
mounting bolt
78).
(Figure 79). If needed, use
Figure 79
3. Back hole
g232012
g025558