Drive System Maintenance; Checking The Seat Belt; Checking The Roll-Bar Knobs - Toro 2000 HDX RD Serie Bedienungsanleitung

Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the Roll-Bar
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
•
Check that both the mounting hardware and the
knobs are in good working condition.
•
Make sure that the knobs are fully engaged with
the roll bar in the raised position.
Note:
The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to fully
engage both knobs (Figure 54 and Figure 55).
1. Roll bar in the upright
position
2. Roll-bar knob in the
latched position
3. Pull the roll-bar knob out
and rotate it 90 degrees.
1. Engaged
44
Figure 54
4. Rotate the roll-bar knob 90
degrees.
5. Roll-bar knob in the
unlatched position
6. Roll bar in the folded
position
Figure 55
2. Partially engaged—do not
operate with the roll bar in
this position.
g036746
g034593