Operating The Mower Blade-Control Switch (Pto); Adjusting The Height Of Cut - Toro eS3200DC 72V Bedienungsanleitung

Operating the Mower
Blade-Control Switch (PTO)
The blade-control switch (PTO) starts and stops the
mower blades.
Engaging the Blade-Control
Switch (PTO)
Ensure that the drive-mode switch is in the F
or N position before engaging the mower
EUTRAL
blades. Refer to Reverse-Mowing Operation (RMO)
Button (page 16) for mowing in reverse.
Figure 18
Disengaging the Blade-Control
Switch (PTO)
Note:
The mower blades automatically disengage
when operating the machine in reverse (when not
using the reverse-mowing button) or when the
operator rises from the seat.
Figure 19

Adjusting the Height of Cut

You can adjust the height of cut from 25 to 127 mm
(1 to 5 inches). Pull the lever to the right, move it to
the desired height, and release the lever into the slot.
Refer to the table for the height-of-cut positions.
ORWARD
g008945
Height-of-Cut Position
1
2
3
4
5
6
7
8
9
10
g009174
21
Figure 20
Height
25.0 mm (1.0 inch)
31 mm (1.2 inches)
39 mm (1.6 inches)
49 mm (1.9 inches)
61 mm (2.4 inches)
73 mm (2.9 inches)
86 mm (3.4 inches)
100 mm (3.9 inches)
113 mm (4.47 inches)
127 mm (5 inches)
g369282