Weidmuller UCV/R Bedienungsanleitung Seite 15

Changingthesetup
For setup mode, connect the security link and press the Å and ì
keys simultaneously. The software version will be displayed (flashing). If
you wish to continue, press within 10 s.
During setup the Å and ì keys change values and toggle options.
The key accepts changes and moves to the next item in the setup
sequence (see table).
Note: If you remove the security link during the setup sequence, any
changes you have made will be discarded.
Clearingtrippedalarms
You can acknowledge a tripped alarm by simply pressing the key for
that channel (ï for Alarm 1 or ENT for Alarm 2).
Displayingthealarmsetpoints
To check a setpoint, simply press the key for that channel (ï for Alarm
1 or ENT for Alarm 2). If the alarms are disabled the display will show
---- .
Adjustingthealarmsetpoints
To change a setpoint, hold down the key for that channel (ï for Alarm
1 or ENT for Alarm 2). You will then be able to change the value using
the arrows. Release the key to save the value.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is
on.
Cleaning
The case can be wiped with a damp cloth. De-energise the unit before
cleaning.
1