Intended Use; Power Supply - Makita LS1040 Bedienungsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. Miter angle
Max. Bevel angle
No load speed
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W) with blade 260 mm in diameter
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
To loosen the bolt, turn it clockwise.
For all countries other than
European countries
For European countries
Bevel angle
0°
45° (left)
LS1040 / LS1040S
25.4 mm, 25 mm or 30 mm (Country specific)
530 mm x 476 mm x 532 mm
11.8 kg
0°
93 mm x 95 mm
69 mm x 135 mm
53 mm x 95 mm
35 mm x 135 mm
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
8 ENGLISH
LS1040F / LS1040FS
255 mm - 260 mm
30 mm
3.2 mm
Left 45°, Right 52°
Left 45°
-1
5,100 min
12.0 kg
/II
Miter angle
45° (left and right)
93 mm x 67 mm
69 mm x 95 mm
49 mm x 67 mm
35 mm x 94 mm