Specifications; Intended Use - Makita DLS714 Betriebsanleitung

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Blade diameter
Blade body thickness
Max. miter angle
Max. bevel angle
No load speed
Dimensions (L x W x H)
Rated voltage
Battery cartridge
Net weight
Cutting capacities (H x W) with blade 190 mm in diameter
Miter angle
0°
45° (left and right)
57° (right)
1. Max. Cutting capacity when using a wood facing 20 mm thickness
2. Max. Cutting capacity when using a wood facing 15 mm thickness
3. Max. Cutting capacity when using a wood facing 10 mm thickness
without notice.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
riage fully and press down handle, then
push carriage toward the guide fence.
blade.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
BL1815N, BL1820, BL1820B
13.0 kg
45° (left)
40 mm x 300 mm
45 mm x 265 mm (NOTE 1)
40 mm x 212 mm
45 mm x 185 mm (NOTE 2)
–
–
-
10 ENGLISH
DLS714
190 mm
1.3 mm - 2.0 mm
20 mm or 15.88 mm
Left 47°, Right 57°
Left 45°, Right 5°
-1
5,700 min
655 mm x 430 mm x 445 mm
D.C.36 V
BL1830, BL1830B, BL1840, BL1840B,
BL1850, BL1850B, BL1860B
Bevel angle
0°
52 mm x 300 mm
60 mm x 265 mm (NOTE 1)
52 mm x 212 mm
60 mm x 185 mm (NOTE 2)
52 mm x 163 mm
60 mm x 145 mm (NOTE 3)
Only for EU countries
Cd
Ni-MH Do not dispose of electric equipment or
Li-ion
battery pack together with household waste
material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.

Intended use

The tool is intended for accurate straight and miter
cutting in wood.
Noise
The typical A-weighted noise level determined accord-
ing to EN61029:
Sound pressure level (L
pA
13.5 kg
5° (right)
40 mm x 300 mm
–
–
–
–
–
) : 88 dB(A)