Cavecool CC34SB Gebrauchsanleitung Seite 12

Before using your wine cooler:
•Remove inner and outer packaging.
•Before connecting the appliance to the electrical socket, leave it in position for 24 hours. This will
reduce the possibility of malfunction of the refrigeration circuit due to transport.
•Clean the inside using a soft cloth and lukewarm water.
Using your wine cooler:
Your wine cellar must be positioned in a room with an ambient temperature between 16 and
+38°C.
If the ambient temperature is higher or lower, the performance of your appliance may be affected and it
may not be possible to obtain designed temperatures.
For model CC34SB/CC62SB/CC102SB, designed temperature is 5-20°C.
For model CC29DB/CC54DB/CC102DB, design temperature is 5-12°C for the upper zone and
12-18°C for the lower zone.
Installing your wine cooler:
•This wine cellar is designed for free-standing installation.
•Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is
level adjust the height of the feet underneath.
•To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
•Connect the appliance to a single socket, leaving a 50 mm gap between the back of the cellar and the
side wall. Be careful to support it, so that your wine cooler is perfectly level. This will prevent any
movement due to instability, generating noise and vibration, and will ensure that the door seals
perfectly.
12