Simons Voss Technologies RouterNode 2 Kurzanleitung Seite 57

RouterNode 2, GatewayNode 2,
All manuals and user guides at all-guides.com
SmartBridge
Reset net-
work config-
uration
IPaddress
User name
Password
EN
1. Disconnect the power supply (round plug or net-
work cable for PoE).
2. Wait 20 seconds.
3. Press and hold the reset button.
4. Reconnect the power supply (round plug or net-
work cable for PoE).
5. Release the reset button after five seconds.
Device flashes green again (see
9
[ 45]
).
}
9 Network configuration is reset.
NOTE
Unauthorised access with standard access data
The standard access data can be viewed freely. Unau-
thorised persons cannot change the access authorisa-
tions, but they can change the network configuration.
You will then no longer be able to reach the device via
the network and will have to reset it.
Change the default password.

You receive the device with the following factory
configuration:
The IP address of your device on your network can be
determined using the free OAM tool (
www.simons-voss.com/de/downloads/software-
downloads.html
information.
192,168,100,100
SimonsVoss
SimonsVoss
). Please refer to the manual for more
9. Reset
Signalling
https://
47 / 184