Replacing The Power Cable; Overload Cut-Out; Cleaning, Maintenance And Ordering Of Spare Parts; Carbon Brushes - EINHELL TKS 1700 Bedienungsanleitung

Anleitung_TKS_1700_4340668:_

11. Replacing the power cable

If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.

12. Overload cut-out

The motor is protected from overload by an
overload switch. If the rated current is
exceeded, the overload switch switches the
appliance off. After a short cooling-off phase,
the appliance can be switched back on by
pressing the overload switch.
13. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before
starting any cleaning work.
13.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the appliance with a clean
cloth or blast it with compressed air at low
pressure.
We recommend that you clean the
appliance immediately after you use it.
Clean the appliance regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
appliance. Ensure that no water can get into
the interior of the tool.

13.2 Carbon brushes

In case of excessive sparking, have the
carbon brushes checked by a qualified
electrician. Caution: The carbon brushes
should not be replaced by anyone but a
qualified electrician.
13.05.2009 14:04 Uhr Seite 25
13.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
13.4 Ordering replacement parts
Please provide the following information on all
orders for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
For our latest prices and information please go
to www.isc-gmbh.info

14. Disposal and recycling

The device is supplied in packaging to prevent
its being damaged in transit. This packaging is
raw material and can therefore be reused or
can be returned to the raw material system. The
appliance and its accessories are made of
various types of material, such as metal and
plastic. Defective components must be
disposed of as special waste. Ask your dealer
or your local council.
Disposal of batteries
Batteries contain substances which are harmful
to the environment. Do not throw batteries into
the normal household waste, into fire or into
water. Batteries should be collected, recycled
or disposed of in an environmentally friendly
way. Send empty batteries to iSC GmbH,
Eschenstraße 6 in D-94405 Landau. There, the
manufacturer will dispose of the batteries in a
professionally appropriate manner.
GB
25