EINHELL TKS 1700 Bedienungsanleitung Seite 15

Anleitung_TKS_1700_4340668:_
narrow workpieces (smaller than 120 mm in
width).
Never cut workpieces which are too small to
hold securely in your hand.
It is imperative for the parallel stop to be
clamped on the right-hand side of the blade
whenever you cut narrow workpieces to
size.
Always stand to the side of the saw blade
when working with the saw.
Never load the machine so much that it cuts
out.
Always press the workpiece firmly against
the saw table.
Make sure that off-cuts do not catch on the
saw blade crown. Risk of catapulting.
Refit all guards and safety devices
immediately after you have completed any
repairs or maintenance work.
Be sure to observe the safety information
and operating and maintenance instructions
issued by the manufacturer, as well as the
dimensions listed in the Technical Data.
It is imperative to observe the accident
prevention regulations in force in your area
as well as all other generally recognized
rules of safety.
Note the information published by your
professional associations.
Connect up the dust extraction system on
all jobs. The operator has to be informed
about the conditions with an influence on
dust development, e.g. the type of material
being processed (source and collection of
the dust), the significance of local
separation arrangements, and the correct
setting of hoods, baffle plates and guides).
Operate the saw only with a suitable
vacuum extraction system or a standard
industrial vacuum cleaner.
Never remove loose splinters, chips or
jammed pieces of wood when the saw
blade is running.
To rectify faults or remove jammed pieces
of wood, always switch off the machine first.
Pull the power plug -
If the sawing gap is worn, replace the table
insert. Pull the power plug -
This electric tool complies with the pertinent
safety regulations.
13.05.2009 14:04 Uhr Seite 17
Keep your work area clean and tidy. Untidy
and unlit work areas can result in accidents.
Keep the tool out of the rain and away from
moisture. The ingress of water into an
electric tool increases the risk of an electric
shock.
Be careful, watch what you are doing and
use an electric tool sensibly. Do not use the
tool if you are tired or under the influence of
drugs, alcohol or medication. A moment of
inattention when using the electric tool can
result in serious injuries.
Do not use an electric tool with a defective
switch. An electric tool that cannot be
switched on or off is dangerous and must be
repaired.
Keep unused electric tools out of the reach
of children. Do not allow people who are not
familiar with the tool or who have not read
these instructions to use the tool. Electric
tools are dangerous if they are used by
inexperienced people.
Keep your cutting tools sharp and clean.
Carefully maintained cutting tools with sharp
cutting edges will jam less and are easier to
control.
If the connection lead on the electric tool is
damaged, it must be replaced by a specially
prepared connection lead available from our
customer service organization.
Have your tool repaired only by trained
personnel using only genuine spare parts.
This will ensure that your tool maintains its
safety standard.
The machine has to be set up where it can
stand securely.
All covers and safety devices have to be
properly fitted before the machine is
switched on.
It must be possible for the blade to run
freely.
When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws etc.
Before you actuate the On/Off switch, make
sure that the saw blade is correctly fitted
and that the machine's moving parts run
smoothly.
Use clamps or a vise to hold the workpiece
securely. This is safer than using your hand.
GB
17