Possible Cause - Silvercrest SKHK 40 C1 Bedienungsanleitung

The following table helps to identify and rectify further possible faults:
Fault
The head-
phones cannot
be switched off.
No sound.
Sound is only
coming from
one side of the
headphones.
NOTE
► If you cannot solve the problem with the solutions given above, please
contact the Service Hotline (see section Service).
SKHK 40 C1

Possible cause

The internal battery is
not charged.
The headphones are
not switched on.
The volume is set to
minimum.
The playback device is
not switched on.
The playback device
has been muted.
The audio cable
incorrectly connected
in AUX-IN mode.
The stereo balance
control on the
playback device is
incorrectly adjusted.
Remedy
Charge the battery (see section
Charging the internal battery).
Press the
2 seconds to switch on the head-
phones.
Set the desired volume using the
button
also increase the volume on the
playback device.
Switch on the playback device.
Unmute the playback device.
Make sure that the audio cable
e
is
is correctly connected to the
AUX IN socket
phones and the playback device.
Adjust the stereo balance control to
the setting you desire.
5
button for about
4
. If necessary,
8
of the head-
GB │ IE │
17
e
■