Filling With Spray Material; Switching The Appliance On/Off; Adjust Spray Pattern; Selecting A Jet Type - Parkside PFSA 20-Li A1 Originalbetriebsanleitung

Filling with spray material

♦ Unscrew the paint cup
♦ To work on a horizontal object, place the riser
pipe in front, facing the nozzle head
work overhead, place the riser pipe
back, facing the motor unit
♦ Fill the paint cup
screw it firmly onto the spray unit
Switching the appliance on/off
Working methods
♦ Hold the spray gun at a constant distance from
the object. The ideal spraying distance is
approx. 15 cm.
♦ Work out the best settings by carrying out a
test.
♦ Do not switch the appliance on/off over the
spray surface. Rather, start/end the spraying
process approx. 10 cm from the spray surface.
Switching on
♦ To switch on, pull the trigger
pressed in.
Switching off
♦ To stop spraying, simply release the trigger

Adjust spray pattern

Set the spray rate
♦ Turn the spray volume adjusting wheel
desired position:
♦ (–) = minimum spray rate
♦ (+) = maximum spray rate
NOTE
► We recommend starting at the minimum
setting.
PFSA 20-Li A1
from the spray unit
at the
.
with the spray material and
.
and keep it
to the

Selecting a jet type

. ♦ Undo the union nut
♦ Turn the protruding parts of the nozzle head
. To so that they point to the desired symbol on the
spray unit
The appliance has the following settings:
▯ round jet
vertical flat jet
horizontal flat jet
♦ Re-tighten the union nut

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
ATTENTION!
► Never immerse the paint spray gun completely
in solvent.
NOTE
► Thorough cleaning after every use is very
important for safety and operation.
.
Otherwise, the needle could get blocked and
proper operation of the appliance cannot be
guaranteed.
■ Wear suitable gloves when cleaning.
■ After every use, squirt water through the
appliance.
♦ To clean the spray unit
nozzles
the supplied cleaning brush
needle
or cleansers which can damage plastic.
♦ Store the device only in dry interior rooms.
.
.
.
, nozzle head
and the spray holes inside, use
, cleaning
or a cloth. Never use petrol, solvents
GB │ CY
,
│
9 ■