Clatronic ar 687 Bedienungsanleitung Seite 106

• The main fuse must be installed as closely as possible (not more than 30 cm
GB
away) to the plus pole of the battery so that the car is protected from any cable
fi re caused, for example, by an accident. If the above is not complied with the
insurance protection no longer applies.
• The cross-section of the plus and minus cable must not exceed 1.5 mm².
• When drilling holes please ensure that none of the vehicle components are
damaged.
Installation Tips:
• Cable protection sleeves protect cables against fraying on sharp body parts.
• The insulation of the cables must not be damaged during installation.
• It is essential to use the correct tools when installing car hi-fi .
Depending on the model, your vehicle may deviate from the above description. We
do not accept any liability for damage caused by installation or connection errors
or for consequential damage.
106
05-AR 687 New.indd 106 05-AR 687 New.indd 106
Installation
Please install the car radio as
shown below
a Nut
b Spring washer
c Plain washer
d Screw
e Mounting bracket
f Slide-in housing
g Threaded bolt
Note:
h Retaining screws during
transport (please remove
before installation)
I Extraction tool (spanner for
dismantling)
j Frame
26.06.2008 13:03:48 Uhr 26.06.2008 13:03:48 Uhr