Other Convenient Rds Functions And Adjustments; Automatic Selection Of The Station When Using The Number Buttons; Setting The Ta Volume Level; Automatic Clock Adjustment - JVC KD-SX1500R Bedienungsanleitung

Other convenient RDS functions and adjustments

Automatic selection of the station when using the number
buttons
Usually when you press the number button, the preset station is tuned in.
However, when the preset station is an RDS station, something different will happen. If the
signals from that preset station are not sufficient for good reception, this unit starts searching
another station broadcasting the same program as the original preset station is broadcasting,
then if any station broadcasting the same program is found, the station will be tuned in.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic program is received,
the volume level automatically changes to the preset level.
• See also "Changing the general settings (PSM)" on page 26.
1 Press and hold SEL (Select) for more than 2 seconds so that "PSM" appears on the display.
¢ or 4
2 Press
The current setting for this function also appears.
3 Rotate the control dial to set the volume to the level (0 to 50) you want.
4 Press SEL again to finish the setting.

Automatic clock adjustment

When shipped from the factory, the clock built in this unit has been set to be readjust
automatically using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
• See also "Changing the general settings (PSM)" on page 26.
1 Press and hold SEL (Select) for more than 2 seconds so that "PSM" appears on the display.
¢ or 4
2 Press
The current setting for this function also appears.
3 Rotate the control dial counterclockwise to select "Adjust Off."
Automatic clock adjustment is canceled.
4 Press SEL again to finish the setting.
To reactivate automatic clock adjustment, repeat the same procedure and select "Adjust
On" in step 3 by rotating the control dial clockwise.
Note:
It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more
than 2 minutes continuously; otherwise, the clock time will not be adjusted
16
repeatedly until "TA Volume" appears on the display, if not shown.
repeatedly until "Auto Adjust" appears on the display, if not shown.