RIB RED Montageanleitung Seite 17

POINT D
- IDENTIFICATION
Each RED is supplied with DIP in OFF to prevent batteries from discharging when
not in use (if connected).
Each RED must be ABSOLUTELY unequivocally identified by putting only one of
the six DIP in ON (SW2).
Only one of the six DIPs must be in ON and the identification must be different
for each RED.
Note: IDENTIFY REDs BY APPLYING NUMBERED STICKERS (SUPPLIED WITH
MASTER) OUTSIDE OF EACH CONTAINER.
Identification of containers serves to rapidly replace dead batteries in RED
indicated by EDGE PHOT LED on MASTER Wi-Fi or MASTER NO TOUCH 868 card.
EXAMPLE OF IDENTIFICATION OF 1 RED
ON A MASTER Wi-Fi or MASTER NO TOUCH 868
6
5
4
3
2
ON
1
MASTER Wi-Fi
MASTER NO TOUCH 868
POINT E
- SETTING AND VERIFY
RECORD A RED AS PEDESTRIAN DOOR SECURITY ON MASTER NO
TOUCH 868
It is possible to record a RED for the pedestrian door only if you have already
recorded the NO TOUCH 868 photocell.
RED transmitter monitors a NC contact (ex: a switch not supplied) installed on the
pedestrian door on the main door.
To run the recording, perform the following procedure:
- Set DIP 2 in ON position (COMPULSORY);
- supply the RED inserting its batteries;
- press the S1 PROG. RX pushbutton which is found on the MASTER NO TOUCH
868: LED DL1 will turn on green and flash for 1 minute (time used to run set up)
- press the S2 PROG. TX pushbutton on RED: on the MASTER NO TOUCH 868 LED
DL1 will stop flashing green and turn off . The buzzer will emit a tone signalling
while the red led of RED flashes 3 times to confirm the correct set up.
EXAMPLE OF IDENTIFICATION OF 3 RED
ON A MASTER Wi-Fi
6
5
4
3
2
1
RED 1 MASTER Wi-Fi
1 2
1 2
6
5
4
3
2
ON
1
RED 1
VERIFY THE CORRECT OPERATION OF THE PEDESTRIAN DOOR
SECURITY
Open the pedestrian door to open the NC contact connected to the RED.
Verify that on the MASTER NO TOUCH 868 the LEDs DL3 and DL4 turn off and
that any door opening command is not performed.
17
OFF
3 4 5 6
ON
3 4 5 6
6 6
5 5
4 4
3 3
2 2
1 1
RED 2 RED 3
G
B
6
5
4
3
2
1