Troubleshooting; Service Data - ZANKER KOB25723XK Benutzerinformation

When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
How to replace: Lamp
Warning! Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
In any cases not included in this table please contact
with an Authorised Service Centre.
Problem
The oven does not heat
up.
The door gasket is dam-
aged.
Before you replace the lamp:
Disconnect the oven from the
Check if...
The fuse is blown.
Do not use the oven.
Contact an Authorised
Service Centre.
Step 2
mains.
Problem
The display shows
"12.00".
The lamp does not work.

Service data

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of the
oven cavity. Do not remove the rating plate from the
oven cavity.
Step 3
Put a cloth on the bottom of the cav-
ity.
Check if...
There was a power cut.
Set the time of day.
The lamp is burnt out.
A
21