Storage; Disposal And Recycling - Scheppach BC52PB Originalbetriebsanleitung

Blade with 8 teeth Ø 255 x 1.5
Transport guard for blade 8 teeth
Safety shield for grass trimmer

11. Storage

Cleaning
• Keep handles free of oil, so you always have a se-
cure hold.
• Clean the equipment as required with a damp cloth
and, if necessary, mild washing up liquid.
m Important!
• Always pull out the spark boot plug each time be-
fore carrying out any cleaning.
• Never immerse the equipment in water or other liq-
uids in order to clean it.
• Store the chainsaw in a safe and dry place out of
the reach of children.
Storage
Important: Never put the equipment into storage for
longer than 30 days without carrying out the follow-
ing steps.
Storing the equipment
If you intend to store the equipment for longer than 30
days, the equipment must be prepared accordingly.
Otherwise the fuel still remaining in the carburetor will
evaporate and leave a rubbery sediment. This can
cause problems when starting up the equipment and
may require expensive repairs.
Slowly remove the fuel tank cap to release any
1
pressure that may have formed in the tank. Care-
fully empty the tank.
2 To remove the fuel from the carburetor, start the
engine and let it run until the equipment stops.
Leave the engine to cool (approx. 5 minutes).
3
Remove the spark plug.
4
Add one teaspoon of 2-stroke engine oil into the
5
combustion chamber. Slowly pull the starter cord
several times to apply a layer of oil to all internal
components. Fit the spark plug again.
Note: Store the equipment in a dry place and far
away from possible ignition sources such as an oven,
a gas-fired hot water boiler, a gas-fired dryer, etc.
Putting the equipment back into operation
1 Remove the spark plug.
Quickly tug on the starter cord to remove excess
2
oil from the combustion chamber.
Clean the spark plug and check that the electrode
3
gap is correct, or insert a new spark plug with the
correct electrode gap.
4 Prepare the equipment for operation.
Fill the tank with the relevant mixture of fuel and
5
oil. See the section „Fuel and oil".
7910700711 Transport
3904801066 To transport the machine, empty the petrol tank as
3904803034 described in section 8 draining fuel.
Clean coarse dirt off the equipment with a brush or
hand brush.
Always assemble the transport protection to all cut-
ting tools Fig. 1 (4a).
To prevent damage and injuries, the device must
be secured against tipping over and slipping during
transport in vehicles.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
GB 27