Daikin RoCon UFH Installation Und Betriebsanleitung Seite 41

Fig. 6-2: Establishing a connection to the controller module (2)
6.3.3 Clear/reset
Fig. 6-3: Deleting a controller module
Commissioning
RoCon UFH
4. Proceed as described above.
Once you have taught in all control cir-
cuits (1 to 2, or 1 to 6) of a product, the
product switches back to normal operat-
ing mode.
If you do not press the LRN key of a room
controller in LRN mode (the yellow control
circuit LED flashes at intervals of one
second) for a period of 30 seconds, the
product automatically switches back to
normal operating mode.
1. Press the CLR key of the product with
the tip of the ballpoint pen (for at least
two seconds) until the yellow LED for
control circuit 1 starts flashing.
- All taught-in room controllers of this
product have been cleared.
- The product is again in teach-in
mode.
EN
39