Establishing A Connection - Daikin RoCon UFH Installation Und Betriebsanleitung

6.3.2

Establishing a connection

Fig. 6-1: Establishing a connection to the controller module (1)
Commissioning
RoCon UFH
1. Press the LRN key of the product with
the tip of the ballpoint pen until the
yellow LED "Control circuit 1" starts
flashing.
2. Within the next 30 seconds, press the
LRN key of the room controller control
circuit 1 with the bent open paper clip.
- If the teach-in process was suc-
cessful, the yellow LED for control
circuit 1 of the product lights up for
several seconds.
If you press the LRN key of the controller
again within the next 30 seconds, the
teach-in process is revoked. If the yellow
LED if off for four seconds, revocation of
the teach-in process was successful.
After successful teach-in or revocation of
teach-in, the yellow LED flashes at inter-
vals of one second.
3. Press the LRN key of the product until
the LED for the next control circuit
flashes (for at least 0.5 seconds).
- The next control circuit is in teach-in
mode.
EN
38