Daikin RoCon UFH Installation Und Betriebsanleitung Seite 36

5.4 Mounting modules on a DIN rail
 Verify that all modules (base module and controller modules) are plugged together
and firmly locked.
 Verify that all cables are connected.
Fig. 5-18: Mounting to DIN rail
5.5 Removing modules from a DIN rail
1. Slightly lift the modules (base module and controller modules) and tilt the top
away from the DIN rail.
2. Remove the modules (base module and controller modules) towards the bottom.
Fig. 5-19: Removing module from DIN rail
Mounting
RoCon UFH
1. Fit the modules (base module and
controller module) onto the DIN rail
with the upper clamps.
2. Push the lower end of the modules
(base module and controller module)
towards the DIN rail until they snap in
with a click.
EN
34