Beko HCA92640BH Bedienungsanleitung Seite 16

3
The vapour is removed via ue pipe which is se-
cured to the connection head on the hood.
Diameter of the ue pipe should be equal to the
diameter of connection ring. To allow the air be
removed easily out of the room in horizontal
arrangements, the pipe should be slightly tilted
upwards (approximately 10°).
Air is ltered by the carbon lter and returned to
the room. Carbon lter is used when there is no
ue in the house.
ıf the hood will be used without ue connection
remove the diverters inside the ue adapter.
Remove the aluminum lter. To install the car-
bon lter, center the carbon lter on the plastic
part on both sides of the fan body, and secure it
on the tabs. Secure the lter by turning the tabs
to right or left.
Install the aluminum lter.
Place adapter supplied together with the hood
into the ventilation hole located on the top sec-
tion of the hood. Procure a pipe with a diameter of
120/150 mm. Connect one end of the pipe to the
adapter and the other end to the ue.
Make sure that these two connections are secure
enough
so that they will not dislocate when the hood
is operated in max. speed. Check that the aps
inside ue are functional when tightened with
the clamp. Fit the ue connection pipe onto the
adapter. If you t the ue connection pipe inside
the adapter, air suction will not occur since the
aps that prevent air back ow will remain closed.
It is not advisable to make connections to the
ues connected with stoves or exhaust shafts. Do
not make connections to such ues.
16 / EN
Pipe connection must be as short as possible and
have minimum number of elbows.
A: Flue outlet pipe
B: Flaps that prevent back ow
C: Plastic ue
3.5.1 Back ow prevention system (N-RV)
When the hood is operated, aps are closed in or-
der to prevent possible odours and dust from en-
tering into the ambient from outside.
Correct
(Figure 9)
Not correct
Hood / User Manual