Beko HCA92640BH Bedienungsanleitung Seite 14

3
Hammer Ø 8 mm wall plugs (X,Y) into the holes
drilled for hanger screws. Hammer 2 x Ø 6 mm
wall plugs (Z) into the holes drilled with a Ø6
mm bit for the external
(Figure 5)
screws
Install 4.8x50 hanger screws into the Ø 8 mm
wall plugs (Y) you have hammered into the wall.
There must be a gap of 5 mm between the screw
head and the wall. (Figure 6)
Connect the internal
6 mm wall plugs (Z) on the wall using Ø 3.9x22
screws. (Figure 6)
4.8 x 50 Cross- 3.9 x 22 Cross-head
head screw screw
(Figure 6)
wall
Hang the hood onto the screws you have
installed into the Y holes.
Open the side suction window of the
hood by pulling it towards yourself. Install
the 4.8x50 screws through the X
holes located inside in order to secure the
appliance.
14 / EN
connection plate.
connection plate to the
Z
Z
Y
X Y
X
Hood / User Manual