Behringer MODEL D Schnellstartanleitung Seite 73

8. Securely connect the 16-pin end P2 of the supplied
adapter cable to your power supply, and double
check all connections are correct.
9. Securely install the MODEL D Synthesizer into your
Eurorack, using 8 screws in the front panel.
10. Perform a full test and safety test before using
the MODEL D.
11. The 3.5 mm MAIN OUT connector on the top panel
is used instead of the 1/4" rear outputs which are no
longer present.
Setting the MIDI Channel
Once installed in a Eurorack, the MIDI channel number is
automatically set to channel 1 (as the MIDI switches are
no longer present.)
The MIDI channel can be changed using MIDI OX or
a similar MIDI utility on your computer to send MIDI
SysEx commands directly to the MODEL D via the
USB MIDI connection. Here is a brief guide to the
procedure (see the MIDI SysEx pages in this manual for
the actual SysEx codes sent to the MODEL D):
1. Disable the MIDI Channel Switches by sending
the appropriate SysEx command.
2. Change the MIDI Channel by sending
the appropriate SysEx command.
73
Quick Start Guide