Small Problems And Solutions - Atag hi170g Bedienungsanleitung

Minor troubleshooting
You have doubts about whether your hob is working correctly .... ...... this does not necessarily
mean there is a breakdown. Nevertheless, check the following points
IF YOU REALIZE
THAT
When you switch on, the display lights up
When you switch on, the fuse blows
When you switch on, only one side of the hob
works
The fan keeps going for a few minutes after the hob
has been switched off
The hob does not work. Displays on the key-
board do not come on
La table s'est arrêtée de fonctionner en cours
d'utilisation et elle émet un "BIP" toutes les 10 se-
condes environ et un
A series of little (or F7 ) appears
The hob does not work, another message comes
on
After having turned on a heating zone, the keyboard
displays continue to flash.
The pans make a noise during cooking
The hob gives off a smell when first used for
cooking
The hob makes a slight clicking
noise.
If the slightest break or crack appears in the ceramic glass surface, disconnect the
unit immediately and contact your After Sales Service.
The hob is working normally
Your hob is connected incorrectly
Your hob is connected incorrectly
The electronics are cooling down
The apparatus is not under power.
There is a power or connection problem.
- Something has overflowed and or an
object is touching the control panel.
,ou F7 s'affichent.
Electronic circuits have overheated.
The electronic circuit is working badly.
The saucepan you use is unsuitable for
induction cooking or its diameter is
under 12 cm. (10 cm on the 160 mm
zone).
This comes from vibrations made by
energy going from the hob to the pan.
A new apparatus
This is caused by power re-
distribution
POSSIBLE
CAUSES
44
WHAT SHOULD
YOU DO?
NOTHING: see chapter Remarks on
connections
Check the connection and make sure it
complies with requirements.
This is normal.
Inspect the fuses and the cut-out
switch.
Clean the hob or remove the object in
question and start cooking again.
See "Fitting your hob".
Call the After Sales Service
See containers.
Under high power this phenomenon is
normal with certain types of pans. There
is no danger for the hob.
Use each heating zone for ½ hour
with a pan full of water.
NOTHING, it is quite normal