Selection Of The Operation Mode (Config) - Omnitronic DXO-26 PRO Bedienungsanleitung

Output Hi Frequency
Output EQ Type
Output EQ Frequency
Output EQ +/-
Output EQ Width

Selection of the operation mode (Config)

The DXO-26 PRO can be adjusted to the following operation-modes: mono, 2-way and 3-way operation.
Please note: if you change the operation-mode, all routings and links will be changed, too. Always select the
operation-mode first. Afterwards, you adjust the output adjustments, routings, delay-links and output
designations.
Select the desired operation-mode in the setup-menu Config and confirm by pressing the Save/Enter-button.
Operation-mode Mono
CHANGE TO MONO ?
ENTER TO CONFIRM
In the operation-mode mono, input channel A is routed to all outputs 1-6. All crossover frequencies are
switched off, i.e. Full Range-signal at all outputs. All delay links is switched off. Stereo Link is not available.
The outputs are named Band 1 to Band 6.
Operation-mode 2-way
Output 4
L
Delay
Link
H
Output 1
In the operation-mode 2-way, input channel A is routed to outputs 1 and 4. Input channel B is routed to
outputs 5 and 6. Outputs 2 and 5 receive a sum signal of inputs A&B. All delay links is switched off. Stereo
Link is switched on. The outputs are named Low and High.
Offset 1-2, 3-4, 5-6
Step 1-2, 3-4, 5-6
Offset 1-2, 3-4, 5-6
Offset 1-2, 3-4, 5-6
Offset 1-2, 3-4, 5-6
Delay
Link
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
Stereo Link
Output 5
L
H
Output 2
Stereo Link
26/33
Output 6
L
Delay
Link
H
Output 3
10356350_V_1_1.DOC