Basic Operation; Editing Parameters - Omnitronic PAD-I2 Bedienungsanleitung

_______________________________________

Basic Operation

1 Always connect the PAD-12 to your computer
before opening the editor.
2 To open the editor insert the supplied CD-
ROM into your CD drive or download and
extract the files. Depending on your operating
system, start the corresponding application.
3 After opening the editor, select the PAD-12
from the opening device select screen.
4 In the main screen, click the control you would
like to modify and edit its assignments in the
lower right pane.
5 You can customize four different scenes by
using the four SCENE buttons near the top of
the editor. Then, you can switch the scenes
on the fly using the BANK button on your MIDI
controller.
6 In order for your adjustments to be reflected in
your MIDI controller you will need to write the
data into the controller. For this, select
Communication > Send Scene Data from the
top menu bar.
_______________________________________

Editing Parameters

Global settings [Common]
The global section lets you can make overall
settings for your MIDI controller for each
scene.
Scene MIDI Channel
This specifies which MIDI channel your
controller will use to transmit MIDI messages
when you operate trigger pads and buttons.
Set this to match the MIDI channel of the MIDI
application you are controlling.
Transport MIDI Channel
Specifies the MIDI channel on which MIDI
messages will be transmitted when you
operate transport buttons.
Set this to match the MIDI channel of the MIDI
application you are controlling.
If you set this to [Global], messages will be
transmitted on the global Scene MIDI Channel.
Pads [Trigger Pads 1 to 12]
Operating a trigger pad will transmit either a
note message or control change message,
depending on the assign type.
For each pad, you can specify the MIDI
transmission channel, the type of operation, its
note number or control change number, and
the values that will be transmitted when the
pad is pressed.
MIDI Channel
Specifies the MIDI channel on which MIDI
messages will be transmitted when you
operate the trigger pad.
Set this to match the MIDI channel of the MIDI
application you are controlling.
If you set this to [Global], messages will be
transmitted on the global Scene MIDI Channel.
Assign Type
This specifies the type of message that will be
assigned to the pad. You can disable the pad
(no assignment), or assign a note message or
a control change message.
Pad Behavior
Selects one of the following two modes:
• Momentary: The Note On or On Value will be
transmitted when you press the trigger pad,
and the Note Off or Off Value will be
transmitted when you release it.
• Toggle: The Note On or On Value will be
transmitted alternately with the Note Off or Off
Value each time you press the trigger pad.
CC/Note Number
Specifies the CC number or note number of the
control change message that will be
transmitted.
On Value
Specifies the On value of the control change or
note on message.
Off Value
Specifies the Off value of the control change
message.
You can set this only if the assign type is
[Control Change].
Transport buttons
Operating the transport buttons will transmit
either control change messages or MMC
messages, depending on the assign type.
For each of these six buttons, you can specify
the message that is assigned, the way in which
the button will operate when pressed, the
control change number, or an MMC command
Assign Type
Specifies the type of message assigned to the
transport button. You can disable the button or
assign a control change message or MMC
message.
Button Behavior
Selects one of the following two modes:
11/12 00068740.DOC, Version 1.0