Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation-mode 3-way
Delay
Link
Delay
Link
In the operation-mode 3-way, input channel A is routed to outputs 1, 3 and 5. Input channel B is routed to
outputs 2, 4 and 6. All delay links is switched off. Stereo Link is switched on. The outputs are named
Channel 1 - Low, Channel 2 - Mid, Channel 3 - High, Channel 4 - Low, Channel 5 - Mid, Channel 6 - High.
This operation-mode is selected when you use a Center Clust where you need the sum of input A and B in
the middle.
Crossover-modes
In this submenu, you can link the crossover frequencies of the corresponding frequency ranges. Both means
linked, Edge means that you can adjust all crossover frequencies individually.
Example: When you change the crossover frequency of the Lo-Output in Both-mode, the frequency of the
Mid-Output is autmatically changed, too. This must not necessarily be the same frequency, as an offset may
be adjusted between the two crossover frequencies.
Delay-units
You can adjust the delay in different units: milli seconds (ms), feet (ft), meters (m) and frames per second
(24, 25 and 30 fr).
Contrast
For adjusting the display contrast.
Safety options
The DXO-26 PRO offers three possibilities to protect the programs and adjustments from unauthorized
access. The simpliest level is lockout, e.g. directly at the event. The Owner Lock and OEM Lock are two
more levels in order to lock individual programs or parameters. For example, you can give the password for
Owner Lock to an other technician, but keep the password for the OEM Lock secret. In this way, you can
protect especially sensitive areas of your programming.
Output 1
L
Stereo Link
Output 3
Stereo Link
M
H
Stereo Link
Output 5
L
Both
M
Edge
L
M
Output 2
Output 6
L
M
L
M
27/33
L
Delay
Link
Output 4
M
Delay
Link
H
10356350_V_1_1.DOC
Werbung
Inhaltsverzeichnis
