Lockout; Owner Lock; Oem-Lock; Midi Channel - Omnitronic DXO-26 PRO Bedienungsanleitung

Lockout

If the lockout is activated, no parameter of a program can be adjusted. This lock is used for avoiding
unintended changes at the device. When lockout is activated, only the display contrast can be adjusted or
the lockout be inactivated.
If you want to save a new program on a locked one, the display shows Program locked. After this message
has disappeared, you can unlock the program with the Next-button or with the jog-wheel.

Owner Lock

If the owner lock is activated, either an individual or all parameters of a program can be locked.
This lock is used for avoiding deliberate changes at the device. When Owner Lock is activated, only the
display contrast can be adjusted or the Owner Lock be inactivated.
Press the >-button in order to enter the password-area. The standard password is SOMA. Enter the new
password via the < / >-buttons and confirm with the Save-button.
Please note: please write the new password down and keep it in a safe place. There is no possibility to
override a password you entered.
the display shows Lock Setup Own. If you want to lock all parameters, set the selection Lockall? to Yes. If
several parameters were locked before, you can unlock all parameters by changing the selection from yes to
no and save with the Enter-button.
If you want to unlock individual parameters, select the respective level by pressing the jog-wheel. Select the
desired parameter via the Prev/Next-buttons. Adjust the desired parameter via the >-button to the parameter
value.
If you want to lock individual parameters, select No. Select the respective level by pressing the jog-wheel.
Select the desired parameter via the Prev/Next-buttons. Adjust the desired parameter via the >-button to the
Locked (hook).
If the memory is sufficient to adjust more equalizers, you have the possibility to lock this feature.
NO MORE EQS OWN
LOCK UNUSED ?
Confirm with the Save- and Enter-button.
Please note: all locked parameters will not be displayed during the operation.
In order to unlock, press the >-button in order to enter the password section. Enter the password via the jog-
dial and < / > buttons and confirm via the Save-button.

OEM-lock

If the OEM lock is activated, either an individual or all parameters of a program can be locked.
Press the >-button in order to enter the password-area. The standard password is OEM. Enter the new
password via the < / >-buttons and confirm with the Save-button.
Please refer to the explanations under Owner Lock.
Please note: if you activate the OEM-lock and save the program (with OEM-lock), the DXO-26 PRO is
completely locked. There is no more possibility to unlock the OEM-lock as described above. In order to make
memory available, you can only delete the program.

Midi Channel

Adjust the desired Midi-channel via the <>-buttons.
Midi can be used to switch the internal programs or to send the complete memory to another DXO-26 PRO
(Sys-Ex Dump).

Midi Mode

In this mode, you can adjust the following settings:
Off
Only the memory content (Sys-Ex Dump) is transmitted, no other Midi-data.
28/33 10356350_V_1_1.DOC