Insert batteries /
rechargeable batteries
according to polarity
marks (+) and (–) on the
battery / rechargeable
battery and the product .
Clean the contacts on the
battery / rechargeable
battery and in the battery
compartment before
inserting!
Remove exhausted
batteries / rechargeable
batteries from the product
immediately .
Before use
Unpacking
Remove the packaging . Check if all
parts are complete .
Clean the product before first use
(see "Cleaning and care") . Dry all parts
thoroughly .
Operation
NOTE: Always use the measuring jug
1 together with the weighing unit 3 .
Only lift up the measuring jug 1 before
cleaning the weighing unit 3 .
24
GB/IE
Removing the insulation
strip
A button cell is already pre-installed in the
battery compartment 8 at the time of
delivery . The button cell is protected against
an early discharge by an insulation strip .
Proceed as follows to remove the insulation
strip (see Fig . C):
Loosen the screw of the battery
compartment cover 8 , using a
screwdriver .
Remove the battery compartment cover
8 .
Remove the insulation strip between the
battery and the contact .
Reattach the battery compartment cover
8 .
Secure the battery compartment cover
8 with the previously loosened screw .
Positioning
Place the product on a horizontal, level and
stable surface .
Switching on/off
Switching the product on:
Briefly press the on/off switch /Z
5 . The LC display 4 will light all its
segments for about 2 seconds . After this,
0 g, 0 : 00.00 lb:oz or 0.00 oz is
displayed .