Troubleshooting - Steinbach S63 Bedienungsanleitung

EN
Cleaning the filter bag, Figure 10, 11, 12, 13, 14, 15, 16
Tips and advices
• Each time the cleaner is removed from the water, the filter element
has to be cleaned.
• The pH-value of the pool water must be between 7.0 - 7.4.
• The water temperature must be between 10 ° C and 32 ° C.
• After pressing the "power off" button, the "power on" button can't be
pressed for 30 seconds.
• We recommend to keep the cleaner between 5 ° C and 40 ° C in a
shaded, well-ventilated place. The supply cable must be wound up
for storage. (The float on the cable must not be moved, so that a
perfect swimming of the cable in the water is maintained) Avoid di-
rect exposure to the sun all the time!
• Before using, please read the instruction for fault rectification thor-
oughly.
• Keep the cleaner always on the handgrip to remove it in and out of
the pool.
Trouble Shooting
Symptom Possible reason
The pool
turns while cleaning
the water (note, this
is normal).
Obstruction in pool.
Cable twists or
coils up.
The cable in the wa-
ter is too long.
Connecting cable is
not long enough.
The cleaner does
not reach all pool
area.
The
doesn't
complete
possible.
The water cycle of
the bath is switched
on.
Too much air in the
case.
The cleaner does
not work.
A foreign object is
in/at drive.
Service processing
Please do not send the unit unauthorized to us, but you should first
contact our service center!
If the product needs to be picked up, so it is necessary to pack it safely
and enclose the invoice (copy) and a copy of the warranty card.
Poolrunner S63 | 2017_V1
Corrective action
cleaner
Unplug power
complete the cable
and unscrew.
Remove obstruction in
pool.
Get the excess part of
the cable from the
water. The cable in the
water has to be long
enough to allow the
cleaner to reach all
corners of the bath.
Allow the cleaner to
reach all corners of the
bathroom, enter
maximum length of the
connecting cable into
the pool, but consider a
corresponding
minimum distance of
the control unit to the
pool.
Slide the pool cleaner
pool shape
by hand to the places
make a
where was not cleaned
cleaning
and restart manually
backwards forwards
Turn off the filter pump.
Turn off the machine
and let all the air
escape.
Contact the
center.
Once the unit has been returned to us, it will be checked for defects
and repaired of our complaints department. After completing this
work, your device will be returned to you as quickly as possible.
If the submission to guarantee isn't justified, then the costs incurred
will be charged.
The Warranty/Guarantee
VertriebsgmbH. The item will be repaired by the company Steinbach
VertriebsgmbH, because there exist no right of return, the pool cleaner
will not be taken back.
Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
e-mail: service@steinbach.at
www.steinbach.at
line,
the
service
runs on the company Steinbach
Page 7 of 44