Steinbach S63 Bedienungsanleitung Seite 5

EN
Warnings
Read all warnings and safety instructions
listed below. Non-compliance with the safety
instruction can result serious
• This equipment is not intended for use by an-
yone (including children) with restricted physi-
cal, sensory or mental ability, or with limited
experience and / or limited knowledge, unless
they are supervised by someone responsible
for their safety, or they receive instruction from
them regarding the use of the equipment.
• In order to prevent severe damage to the
cleaner, never power on the unit when it is out-
side of the swimming pool!
•
The device must be connected to an earthed
230 V protective contact
• Do not operate the cleaner when people are
in the pool.
•
If you pull the cleaner out of the water, do not
grasp the unit directly to the cable but at the
retaining bracket.
• Before switching on the unit and let espcape
the complete air.
•
Before power on, make sure the cable is fully
released to avoid any winding, which could
affect the cleaner's performance or cause
damage.
• The filter bags should be cleaned immedi-
ately every time you use the unit.
• The cleaner should be stored in a cool and
ventilated place, away from direct sunlight,
when not in use.
• The power supply unit should be placed in a
shaded area. In order to avoid overheating and
the potential damage of components, never
cover the power supply unit.
• Only authorized after sales service personnel
should open and repair the cleaner's motor as-
sembly and power supply unit.
•
The cleaner may only be used to clean
swimming pools. Any other use wages to the
immediate maturity of the warranty
•
Children may not use the
• The cleaner is not a toy.
• Do not uncover the protective film which is
sticked on the operating panel.
Poolrunner S63 | 2017_V1
accidents.
socket.
claim.
cleaner.
Warnings
The automatic pool cleaner is not suitable for
swimming pools with a foil thickness of less
than 0.4 mm. It may be possible in certain
circumstances that the liner gets damaged. A
use of the pool cleaner below the specified foil
thickness is at your own risk.
Introduction
Our automatic swimming pool floor cleaner Speedcleaner „Poolrunner
S63" is a new, powerful and automatic system for cleaning swimming
pools. Through its advanced computer controlled program, it can
clean the pool floor automatically without draining pool water. At the
same time, it filters the pool water and gets rid of suspended particles
and sediments. The Poolrunner S63 can only absorb loose debris
particles from the floor. An adherent contamination must still be
removed manually. For safe operation, the cleaner works on 24V di-
rect current. Please read these instructions carefully in order to use it
properly.
The automatic pool cleaner can be used for almost all standard pools
with flat, level ground.
Safety
Your cleaner has been carefully tested after
manufacture and left the factory in perfect
technical condition. To maintain this orderly
condition and to ensure safe operation, the
user should always adhere to all recom-
mended instruction in this manual. If there are
indications that safe operation of the pool
cleaner can not be guaranteed, the product is
to be immediately unplugged from the electric-
ity supply and prevented from unintended re-
connection.
This is the case:
Ø if the device shows visible damage
Ø if the device
operational
Ø after prolonged
unfavorable conditions
When the power cord or other parts of this
appliance is damaged, it must be replaced by
the manufacturer or its service agent or a
similarly qualified person in order to avoid a
hazard.
Transport damage
Your Poolrunner S63 was packed carefully for
the transport. Please ensure when taking over
no longer seems
storage under
Page 5 of 44