Technical Data - Lux Tools 115315 Originalbetriebsanleitung

115315_Schredder_Benzin.book Seite 46 Dienstag, 31. Mai 2016 10:54 10
GB
Error/Fault
Motor does not start, or operates
unevenly.
Motor overheated.
Motor is vibrating or generating
unusual noises.
Cut size of shredded material is
not small enough.
Shredded material no longer
comes out of the ejection chute,
or only very slowly.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
46
Possible cause
The safety switch is not posi-
tioned correctly?
Tank empty?
On / off switch set to [0]?
Spark plug connector is not cor-
rectly fitted to the spark plug?
Incorrect spark plug?
Level of motor oil is too low?
Fuel line blocked?
Fuel old and stale?
Water or dirt in the fuel?
Motor defective?
Is the air filter soiled?
Loose or damaged parts?
Shredded material in feeder
chute?
Blades are blunt or damaged?
Loose, worm or damaged drive
belt?
Ejection chute blocked?
Motor revolutions too low?

Technical data

Item number
Cubic capacity
Performance
Cooling system
Max. branch thickness
Max. motor speed
Max. cutting revolutions 2400 min
Dimensions
(length × width × height
)
Net weight
Noise pressure level
(L )*
PA
Remedy
Check the safety switch
Filling with fuel.
Set the On / Off switch to [1].
Affix the connector firmly to the
spark plug.
Technical data
Checking the level of the motor
oil.
Clean the fuel line.
Clean the air filter.
Allow the motor to run until all of
the fuel has been used up. Fill
with fresh fuel.
Clean the motor.
Clean the air filter.
Check the device for loose or
damaged parts.
Clean the feeder chute.
Changing the blades.
Have it tensioned or replaced by a
specialist.
Clean the ejection chute.
Warm starting.
115315
159 cm³
3.0 kW
Air cooled
50 mm
-1
3600 min
-1
1000 mm × 430 mm ×
865 mm
40 kg
90 dB (A)