Cleaning And Maintenance - Lux Tools 115315 Originalbetriebsanleitung

115315_Schredder_Benzin.book Seite 42 Dienstag, 31. Mai 2016 10:54 10
GB
– Check the seal of the tank lid (8) for damages
and clean if necessary.
Immediately replace the seal if damaged!
– Tighten the tank lid (8) by hand.
Starting / stopping the motor
Figure 7 – Page 5
– Set the On / Off switch (6) to [1].
Cold starting
Figure 8 – Page 5
– Activate the fuel pump (23) 1-2 times.
– Pull the starter cord (10) out until you start to feel
resistance and then allow it to release.
– Repeat until the motor starts.
– If the motor does not start after a number of
attempts, consult the section on troubleshoot-
ing.
Warm starting
Figure 7 – Page 5
– Set the On / Off switch (6) to [1].
– Pull the starter cord (10) out until you start to feel
resistance and then allow it to release.
– Repeat until the motor starts.
Stopping the motor
– Set the On /Off switch (6) to [0].
– Stopping the motor.
Shredding
Note: The feeder chute has two openings.
If the cut size of the shredded material is
not small enough after shredding, the
shredded material must be returned to the
feeder chute.
WARNING! Risk of injury! Only use a
suitable push rod for pushing material fur-
ther into the cutting chamber. Never reach
into the feeder chute with your hands.
CAUTION! Risk of damage to the unit!
To prevent the device from becoming
blocked, ensure that the feeder chute is
never overfilled nor filled with damp or wet
material.
Figure 9 – Page 5
– Use the front feeder chute opening (24) for
leaves and small material.
42
– Use the rear feeder chute opening (25) for
medium to large sized material.
Instructions for shredding
Noise disturbance! This device may not
be used during the customary local rest
periods.
• Cut up organic garden residues may be used as
biological fertiliser for the garden. Fill biodegrad-
able material such as leaves, small branches and
grass into the unit in measured amounts.
• Cut material can be collected in a container
below the ejection opening.
• Only feed in material in quantities that do not
block the feed hopper.
• Alternate between dry twigs and dry garden rub-
bish that has been stored for several days and is
thus limp. This prevents the blades from block-
ing.
• Soft waste such as kitchen waste is not suitable
for the device and should be composted.
• Before new material is fed in, heavily branched
material with leaves must be completely cut up.
• Smaller objects and soft material such as leaves
can be fed better into the device using a push
rod.
• Heavy material or branches will cause the blades
to block if you attempt to cut them with no
breaks. Pull the material out by hand a short way
in order to counteract this problem.
• Carefully inspect the material to be cut. The
device may become seriously damaged from
stones, nails or similar objects.
• Strong vibration of the shredder indicates dam-
aged or blunt blades. In this case, replace
blades.
• Only switch device off when all material to be cut
has passed through the shredder. Otherwise the
device may be blocked when switched on again.

Cleaning and maintenance

DANGER! Risk of injury! Switch off
device and remove the spark plug con-
nector before carrying out any cleaning
and maintenance work. Wait until all mov-
ing parts have come to a standstill and the
device has cooled down.
WARNING! Risk of injury! Before carry-
ing out any maintenance work, always
switch the device off and remove the
spark plug connector.