Lux Tools 115315 Originalbetriebsanleitung Seite 39

115315_Schredder_Benzin.book Seite 39 Dienstag, 31. Mai 2016 10:54 10
• Always comply with the all applicable domes-
tic and international safety, health, and work-
ing regulations.
• When working, ensure you always use a nat-
ural and secure stance.
• Do not force the power tool. Only use the
device for its intended purpose.
• People who do not have the physical, mental
or sensory abilities to operate the device
carefully and safely may not be permitted to
use it.
• Always work with care and when you are in
good form: If you are tired, ill, if you have
ingested alcohol, medication or illegal drugs, do
not use the device as you are not in a condition
to operate it safely.
Operation / workplace
• Only put the device into operation if no
defects were found when it was checked
over. If a part is defective, it must be replaced
before the device is used again.
• When operating the device ensure that the
area you are working in is clean and tidy. Do
not leave tools, objects or cable laying around in
the vicinity of the device.
• When working with the device make sure the
area is well lit.
• Make sure that flammable materials or mate-
rials that may explode are kept out of the
immediate vicinity.
• Individuals under the age of 18 and those not
familiar with the operation of the device
should not be allowed to operate the device.
• Make sure to always wear the required per-
sonal protective clothing.
• Keep children and bystanders away while
operating the device. Distractions may cause
you to lose control of the device.
• When working with the device, ensure a
secure stance! Make sure that you cannot slip
or fall down. Do not bend forwards or lean over
backwards!
Device-specific safety information
Note
• Read these operating instructions carefully
before using the device.
Preparation
• Never allow children to use the device.
• Never use the device when there are people
in the vicinity.
• Carbon monoxide can be very dangerous in
enclosed spaces. Never operate motorised
machinery in enclosed spaces as motor
exhausts contain carbon monoxide which is a
gas that is colourless, odourless and tasteless.
• Wear goggles and ear defenders. Where these
all the time the device is operating.
• Do not wear loose fitting clothes or clothes
with hanging bands or cords.
• Only use the product out in the open, i. e. not
close to a wall or other solid object and make
sure it is on a solid, even surface.
• Do not use the device on a paved and with
gravel covered surface. This type of surface
may throw back ejected material which can
cause injuries.
• Before starting the device up, check all
screws, nuts, bolts and other fixtures to
ensure that they are fitted tightly and make
sure that all covers and guards are in place.
Labels that are damaged or cannot be read must
be replaced.
• Be particularly careful when using petrol. It is
highly flammable and the vapours are explosive.
The following points should be observed:
• Only store petrol in containers designed for
the purpose.
• When the motor is running or when the
machinery is hot, do not open the tank lid or
refill with petrol. Allow both the motor and the
exhaust components to cool down before refill-
ing.
• Do not smoke.
• Only fill the tank outdoors.
• Never store the device or the petrol canister
in an enclosed space with a naked flame, e. g.
a water boiler.
• If petrol is spilled, do not attempt to start the
motor. Instead, remove the device from the pet-
rol contaminated surface.
• For safety reasons, the petrol tank and other
tank caps must be replaced if damaged.
Operation
• You can only take the device into operation if
the feed hopper has been correctly mounted.
If installation has not been carried out correctly,
the safety switch will prevent you from starting
up the device.
• Make sure that the feed hopper is empty
before starting the device.
• Keep a good distance between the feed hop-
per and your head and body.
GB
39