Your Device At A Glance - Lux Tools 115315 Originalbetriebsanleitung

Verfügbare Sprachen

115315_Schredder_Benzin.book Seite 40 Dienstag, 31. Mai 2016 10:54 10

• Never put hands or other parts of the body or

clothing into the feed chamber, ejection

channel or in the vicinity of other moving

parts.

• Always pay attention to your balance and

ensure you are standing firmly. Do not lean for-

wards. Never stand higher than the device when

feeding in material.

• When operating the device, make sure you

are standing outside the ejection zone.

• When feeding material into the device, make

sure that there are no metal objects, stones,

bottles, cans or other foreign objects hidden

inside the material.

• If foreign objects are drawn into the cutting

mechanism or the device makes unusual

noises or vibrates abnormally, immediately

stop the motor and allow the device to come

to a standstill. Remove the spark plug connec-

tor and carry out the following tasks:

– Check the device for damages.

– Check all parts to make sure that they are tight-

ened firmly, and tighten if necessary.

– Have all damaged parts replaced or repaired.

Make sure that the parts used have the same

qualities.

• Do not allow processed material to build up

within the ejection zone as this may hinder

correct ejection and lead to material being

kicked back through the opening.

• If the device is blocked, switch the motor off

and remove the spark plug connector before

you start to clean it out. Make sure that the

motor is free of waste and other accumulations

in order to prevent damage to the motor or fire.

• Remember when the start mechanism of a

motorised machine is used, the cutting tool

also starts to operate.

• Make sure that all covers and guards are in

place and in good working order.

• Do not change the regulation setting of the

motor. The revolution regulates the safe maxi-

mum operating speed and protects the motor

and all of the rotating parts from damages

caused by excess speed. If you have any prob-

lems, contact customer service.

• Never transport the unit with the engine run-

ning.

• Switch the motor off immediately when you

leave work area and remove the spark plug

connector.

• Never transport the device with the engine

running.

Maintenance and storage

• If the device is switched off for the purpose of

maintenance, storage or to replace an acces-

sory, ensure that the power source is deacti-

vated and the spark plug connector removed.

Ensure that all of the moving parts have come to

a standstill and, if there is a key, remove it. Allow

the device to cool down before carrying out

maintenance, adjustment work etc.

• Store the device in a location in which it is not

possible for petrol fumes to come into con-

tact with naked flames or sparks. Drain the

petrol if you intend to store for a longer period of

time. Always allow the device to cool down

before storing.

• When carrying out maintaining on the cutting

tools remember that these will still operate

when the starting mechanism is used, even if

the motor does not run because the of the

cover lock mechanism.

Personal protective clothing

Wear goggles and ear defenders when

using the device.

When working with the tool, wear stur-

dy footwear.

Wear safety gloves when working with

the device.

Wear tight fitting clothes when working

with the device.