Cleaning And Maintenance - Dometic COOLFREEZE CF11 Bedienungsanleitung

CoolFreeze
Replacing the plug fuse (12/24 V) (fig. 5, page 3)
6.12
➤ Pull the adapter sleeve (4) off of the plug.
➤ Unscrew the screw (5) out of the upper half of the housing (6).
➤ Carefully lift the upper half of the housing off the lower half (1).
➤ Take out the contact pin (3).
➤ Replace the defective fuse (2) with a new one that has the same rating (T8A 32V).
➤ Re-assemble the plug in the reverse order.
6.13 Replacing the bulb (CF16, CF26)
➤ Press the switch pin (fig. 6 2, page 3) downwards so that the transparent part
(fig. 6 1, page 3) of the lamp can be removed at the front.
➤ Replace the light bulb.
➤ Press the lamp back into the housing.
7

Cleaning and maintenance

!
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
EN
Cleaning and maintenance
15