Attention; Advice - Elite Super Crono HydroMag Digital Bedienungsanleitung

GB

ATTENTION

• The resistance unit becomes warm when in use.
Wait until it has cooled before touching the alumi-
nium shells.
• Do not brake when using the trainer, as this can
permanently damage the roller and the tyre.
• The stand is designed for use by just one
cyclist.
• Check the safety and stability of the bicycle before
every training session.
• If the quick release is not compatible with the
bushings of the stand, replace it with the one
supplied (P).
• The computer that is applied on the handlebar
is not waterproof. Take care not to sweat over the
display, because it could damage the electronic
circuit.
• Do not store the Super Crono Hydromag Digital
in damp or wet places. This could damage the
electronic components.
• If the trainer is not going to be used for a long
time, it is advisable to remove the batteries from
the computer and the transmitter.
• There are no individually usable components on
the inside. The warranty is invalidated if the unit
is opened or tampered with.
• Since the feet are made from soft non-slip ma-
terial, during use they may leave rubber marks on
the floor.
• During use of the Super Crono Hydromag Digital
with Elastogel roller, slight wear of the roller is
to be considered normal. Tests carried out at Eli-
te show that after continuous use for 20,000 km,
roller wear is around 0.1 mm, and as the total
thickness is 17.5 mm, far greater wear does not
prevent correct operation of the trainer.
12
1 Supercrono HydroMag Dgt.indd 12
Claims due to improper or careless use will not be
acknowledged. Possible slight wear of the rubber
part comes within the norm.
• Use with narrow tyres or with non-optimum tyre
pressures can permanently damage the Elastogel
roller.
• If slipping of the wheel on the Elastogel roller is
noticed, apply a more gradual force on the pedal.
Training with the tyre slipping can permanently
damage the Elastogel roller.

ADVICE

• For less tyre wear and better grip on the roller, it
is advisable to use tyres of 23 mm width.
• Recommended rear wheel pressure: 7 -8
atmospheres for racing tyres; 3.5 - 4 atmospheres
for MTB tyres. For particular cases, comply with
the pressure recommended by the tyre manufac-
turer.
• For quieter use, better grip of the tyre on the
roller and reduced vibration, use slick tyres (also
for Mountain bikes).
• Before use, clean the tyre with alcohol or water.
• If the pin of the quick release supplied protrudes
more than 3 mm from the fixing nut, cut off the
protruding part (fig. 4).
4
05/11/09 12:21