Valve Clearance Adjustment - Yamaha WR426F Handbuch

VALVE CLEARANCE ADJUSTMENT

3 - 20
4. Check:
Valve clearance
G
Out of specification → Adjust.
Valve clearance (cold):
Intake valve:
0.10 ~ 0.15 mm (0.0039 ~ 0.0059 in)
Exhaust valve:
0.20 ~ 0.25 mm (0.0079 ~ 0.0098 in)
Checking steps:
Turn the crankshaft counterclockwise with
G
a wrench.
NOTE:
Squeezing the decompressor lever allows
the crankshaft to be turned easily.
Align the T.D.C. mark a on the rotor with
G
the align mark b on the crankcase cover
when piston is at T.D.C. on compression
stroke.
NOTE:
In order to be sure that the piston is at Top
Dead Center, the punch mark c on the
exhaust camshaft and the punch mark d on
the intake camshaft must align with the cyl-
inder head surface, as shown in the illustra-
tion.
Measure the valve clearance e using a
G
feeler gauge 1.
NOTE:
Record the measured reading if the clear-
ance is incorrect.
INSP
ADJ