Inhaltsverzeichnis
Werbung
9. Install the new brake on the shaft.
1.
Secure the fixation with the three
screws. Pre-tighten the screws by
hand.
2.
Tighten the screws with a tool.
3.
If the brake has two more screws,
remove the screws.
There may be two extra screws on the
brake. The screws are used during
transportation to keep the brake
HINWEIS
components together. Remove these
two screws when you have installed the
new double brake.
The top brake is the main brake, and the
HINWEIS
bottom brake is the secondary brake.
10. Plug in the brake cables (1) and (2).
11. Install the end cover on the brake side.
For more information, see chapter Removing and installing the hoist covers.
12. Tighten the screws of the end cover to the correct tightening torque.
For more information, see chapter Tightening torques for the chain hoist.
13. Turn on the power to the hoist.
14. Check that the brake works normally.
1.
First test the brake without any load.
2.
Then test the brake with a dynamic test load of 110% (EUR) or 125% (US) of the rated
capacity. Size of the dynamic test load depends on the country regulations.
3.
In the European countries, test the brake also with a static test load of 125% of the
rated capacity.
7.4.6
Replacing the double brake
1. If a load is attached to the hook, remove it.
2. Disconnect the chain hoist from the main power supply network.
3. Remove the end cover on the motor side.
Dieses Dokument und die darin enthaltenen Informationen sind das alleinige Eigentum von Verlinde S.A.S. und stellen
ein Geschäftsgeheimnis dar, d.h. das Dokument und die Informationen sind vertraulich, gesetzlich geschützt und nicht
für die Öffentlichkeit bestimmt. Ohne ausdrückliche schriftliche Genehmigung von Verlinde S.A.S. darf der Inhalt dieses
Dokuments weder verändert, vervielfältigt, an Dritte weitergegeben oder anderweitig verwendet werden. Copyright
2020 © Verlinde S.A.S. Alle Rechte vorbehalten.
2
1
1. Main brake
BENUTZERHANDBUCH
2. Secondary brake
4/2020
Werbung
Inhaltsverzeichnis
