Inhaltsverzeichnis
Werbung
7. Reassemble the hook block.
7.1 Insert the rubber plate or the magnetic
limit switch activator (2) on the new
chain on the hook end of the chain.
7.2 Insert the rubber cover of the hook
block (1) on the chain.
7.3 Insert the pin (5) through the first chain
link of the chain.
7.4 Attach the pin into one of the hook
block halves (3).
7.5 Assemble the hook block.
7.6 Secure the fixation with the two screws
(4).
8. Pull the rubber plate or the limit switch
activator up on the chain. Attach the end
stop to the chain end on the chain bucket
side of the chain fall.
The dimension 'W' should be at least
150 mm (5.9 in). The dimension 'W' is
HINWEIS
the distance from the end of the chain
to the bottom of the end stop.
9. Place the chain into the chain bucket. Attach the chain bucket to the chain hoist.
For more information, see chapter Fitting the chain bucket.
10. Perform the functional tests and the load tests.
Perform the functional test up and down. If local regulations require it, perform also the load
test. Pay attention to the chain and make sure it drives straight into the chain hoist.
7.5.5
Replacing the chain
Replacement of the chain sprocket
If the chain wear exceeds 2% when you replace the chain, also the chain sprocket must
HINWEIS
be replaced. If the chain has been replaced before but without replacing the chain
sprocket, replace the chain sprocket. Because of the wearing, it is recommended to
replace the chain sprocket every time when the chain is replaced.
Replacement of the chain guide
HINWEIS
The replacement need of the chain guide depends on the wear level of the chain guide.
1. If a load is attached to the hook, remove the load.
2. Remove the chain bucket.
For more information, see chapter Removing the chain bucket.
Dieses Dokument und die darin enthaltenen Informationen sind das alleinige Eigentum von Verlinde S.A.S. und stellen
ein Geschäftsgeheimnis dar, d.h. das Dokument und die Informationen sind vertraulich, gesetzlich geschützt und nicht
für die Öffentlichkeit bestimmt. Ohne ausdrückliche schriftliche Genehmigung von Verlinde S.A.S. darf der Inhalt dieses
Dokuments weder verändert, vervielfältigt, an Dritte weitergegeben oder anderweitig verwendet werden. Copyright
2020 © Verlinde S.A.S. Alle Rechte vorbehalten.
BENUTZERHANDBUCH
1
5
w
2
3
4
4/2020
Werbung
Inhaltsverzeichnis
