Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
is damaged, it must
be replaced by the
manufacturer, its
service agent or
similarly qualified
persons in order to
avoid hazard.
WARNING: Use
only stovetop pro-
tectors designed by
appliance manufac-
turer or indicated by
the manufacturer in
the instructions for
use as adequate or
stovetop protectors
incorporated into the
device. The use of
inadequate protec-
tors can cause acci-
dents.
It is necessary to
allow the appliance
disconnection after
i n s t a l l a t i o n .
Disconnection devi-
ces must be incorpo-
rated to the fixed
electrical installa-
tion, according to
the installation regu-
lations.
Attention! Never
place cookware nor
utensils on the touch
screen area. Hot
fig. 2
24
objects on it can also
cause irreversible
damage.
Installation
Installation with cutlery drawer
If you wish to install furniture or a
cutlery drawer under the hob, a sepa-
ration board must be fitted between
the two. Accidental contact with the
hot surface of the device's housing is
thus prevented.
The board must be fitted 20 mm bene-
ath the under part of the stovetop.
Electrical connection
Before you connect the stovetop to
the mains, check that the voltage
and frequency match those specified
on the stovetop nameplate, which is
underneath it, and on the Guarantee
Sheet, or if applicable on the technical
data sheet, which you must keep
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
top housing or the oven housing, if it
is installed in the same unit.
Warning:
The electrical connection must
be properly grounded, following
current legislation, otherwise the
induction hob may malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
high temperature that this type of
device attains.
Only the TEKA official techni-
cal service can handle or repair the
appliance, including replacement
of the power cable.
Before disconnecting the hob
form the mains, we recommend
switching off the cutoff switch and
waiting for approximately 25
seconds before disconnecting from
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical
data sheet together with the
instructions manual throughout
the product's service life. These
contain important technical
information.
Use and
Maintenance
Instructions of use of the
Touch Screen
ELEMENTS OF THE CONTROL
PANEL (fig. 2)
1 General on / off sensor.
2 Touch screen.
3 On indicator light.
Operations are carried out via the
touch screen (2). It is not necessary
to press hard on the glass; by just
touching it with your finger, you can
activate the desired function.
TURNING ON THE DEVICE
Werbung
Inhaltsverzeichnis
